trying to write a program that takes input from Sensor and outputs to LED

In assembly language how do I write code to take input from a sensor and turns on a LED?
I'm writing an assembly program that will read information from a sensor that will detect whether its raining or not. the sensor will be the input and the LED will be the output indicating that its raining.
I have code written for 5 other weather conditions but right now I just want to figure out the most basic which is rain.

here's my code///////////////////////////I just want to know if I'm headed in the right direction, If not do you have any suggestions///////////////////

Code:

---

#include <p16F690.inc>
;----------------------------
;define equates here
;----------------------------
count equ 0x00
sum equ 0x09

rainLed equ 4
rainSensor 10

dayOrNightLed equ 3
dayOrNightSensor 9

windLed equ 2
windSensor 8

snowLed equ 1
snowSensor 7

tempLed equ 0
tempSensor 6

fogLed equ 0
foqSensor 5

;---------------------------
;start of program
;---------------------------

org 0x0000 ; tells program to start at first location
start:

BSF status, RP0 ; select bank 1
BCF status RP1

movlw b'11111000' ; make bank 5-10 inputs
movwf TRISA ;make bank 4-0 output

BCF status RP0 ;bit clear file
BCF status RP1

;------------------------------
;Loop
;-----------------------------
BTFSS PortA, rainSensor
BSF PortA,rainLed

---

is this part right so far?????????????????

initialize your thing--- system, dos or asm. BASIC is a program
define your variables-
address your starting, ending and offset.-
build your exe-

[SYSTEM]
for sensors(1 to n)
next n
if sensors(n) > 1
then trigger.system.led1 ; lights led1
else sensors(n) = 0