What is?

[dominic-neons]

What is the equivalent of C++'s CPropertyPage in VB.NET?

[dominic-neons]

OK, what's the matter? No one's answered.

Is this Question:

a) too hard for the users here ?

b) too stupid for the users here ?

[Andreas Masur]

Originally posted by dominic-neons
OK, what's the matter? No one's answered.

Is this Question:

a) too hard for the users here ?

b) too stupid for the users here ?

Well...this is not the kind of behaviour people expect around here. First of all you should remember that everybody contributing on this forum does it on his/her free time and without getting paid. Most-likely all of us have school, job etc. therefore you cannot expect an answer within five minutes. It might happen but it is not guaranteed.

The second thing I would like to remind you is that Visual Basic .NET (as well as the whole .NET package) is still pretty much new and not that common in the development areas. Therefore it might just be that only a few people would know about this and they might not even be on the board.

I also cannot answer your question since I did not look that deep into Visual Basic .NET yet...so see this post just as a remark since you are pretty new to the board (at least from looking at the number of posts you made...)

[dominic-neons]

Actually I resent you telling me that I had the wrong behaviour. I asked two honest questions, after my initial question went unanswered for over a week. I needed to know if the question was above or below the skillset here. In either case, I would need to go other places to find my answer. Sometimes on FORUMs questions will go unanswered for two reasons, either it is too stupid to be asked or too complicated for the FORUM's users. It appears from your response it is the latter not the former here. So I will move on to other FORUMs in search of the answers.