-
June 16th, 2004, 01:55 AM
#1
PWM through serial port
I want to run a servo through a serial port and I dont know where to start. All the the articles I looked had a pic controlling the servo. since I only want to control one servo, I was thinking I could do it directly through a serial port and control the movement through software.
Is this possible at all ?
Thanks a lot in advance
any suggestion is deeply appreciated
Thanks
-
June 27th, 2004, 05:06 PM
#2
it wld be easier to use a parallel port. just use what lines you need.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
Click Here to Expand Forum to Full Width
|