Alright, so here's the problem and for the life of me I can't figure it out:
Task: Creating a report that lists all of our medically disabled employees. Must be a single line report (i.e. can not group and then list underneath).
Problem: Some employees have more than one disability. This causes them to appear multiple times on the single-line report.
This is the table inside of my program that I am pulling from. This table is for a single employee. Notice how more than one disability is listed: (See bardistable.jpg below)
This is the results of my report when I run it in Crystal: (See reportresults.jpg below)
Somehow, I need to figure out a way to only show the first disability an employee has listed on their table. Like in employee 0077's case, I only want to see disability D02... not D04 and D05 too.
I DID find a solution to this by way of Section Expert > Suppress (No Drill-Down) > previous({hrpersnl.p_empno})={hrpersnl.p_empno}. But I can not use this formula because it causes my first employee to be suppressed for some reason.
* The Best Reasons to Target Windows 8
Learn some of the best reasons why you should seriously consider bringing your Android mobile development expertise to bear on the Windows 8 platform.
Reply With Quote
